At Carnopy we are continually reviewing and improving our products.

In Spring 2007 we introduced the suction cone version for the Carnopy™ Weekender. The initial Suction cone version was shipped with the original straps of the earlier 2006 model. Please see the first set of instruction if you have this version. It will show how to use the straps to help secure your suction cone to the car.

In late spring/early summer 2007 the new suction cone version will be available. No more straps required as this cone really will “Stick”. Please see the second set of instructions if you have this model.

Please note: The Carnopy™ itself is still the same in all aspects except for the means of securing it to your car. We hope the new suction cone will make life easier for all our customers.

In June 2007 the new cones will be available to purchase as an upgrade. Prices and availability are to be confirmed.

Please feel free to call or e-mail us at Carnopy if you have any customer service issues. Our friendly team are always willing to help and give advice.

Whilst the Carnopy™ is not complicated to assemble, it is a new concept. Therefore we suggest you take a few minutes to read the information below or download the relevant Instructions via the links above and familiarise yourself with the different parts. It will save you time when you first assemble the product.

Your Carnopy™ is provided with a variety of straps. Please check the contents of the bag against the list below to make sure you have all of the necessary parts to assemble your Carnopy™. Once you have identified the straps please refer to the next page for the correct configuration for your vehicle; hatchback, side opening rear door, small van, large van etc.

STRAP A (25cm): 4 x Short straps with a ‘D’ ring and a buckle at the end.

STRAP B (100cm): 4 x Long straps with nylon hook at one end.

CONES: 2 x Roof Cones, Carnopy™ Dome Rests & Protective Rubber Rings.

FIG. A - STRAPS FOR HATCHBACK DOORS/BONNETS:
Fig.A is for hatchback cars, where you will fit the straps to the top and bottom of the door or bonnet. The cones will therefore be fixed on the back door/window/bonnet ready to have the Carnopy™ clipped to them.

A-1 (x2) Clip straps to top of closed door/bonnet

A-2 (x2) Clip straps to bottom of closed door/bonnet

Step 1: Having Assembled the straps (A or B), fix to rear door or roof for side hinged doors. (Use the extension straps if required.)		Step 2: Velcro Top pole section into front corners so that spike goes through the eyelet.
Step 3: Slide the three section steel pole into the rear sleeve and join in the middle.		Step 4: Hook the tab over the spike at each end of the steel poles.
Step 5: Lay out the fabric and insert the fibre poles into the roof sleeves		Step 6: Connect the fibre poles to the spikes in the 4 corners.
Step 7: When in position, the fibre poles will create a dome shape.		Step 8: Clip the Carnopy™ to the cones and loosely strap to the rear bibs.
Step 9: Place out the front legs and then open the door.		Step 10: Adjust bibs and wheel arch strap to secure tightly.

Carnopy™ is a registered trademark of Carnopy Ltd

© Carnopy Ltd 2005-2007